RE: [MLUG] changing nics

["Nowlin, Dan" <EMAIL:PROTECTED>]

Using the same cable as before and plugged into a switch.  Not sure if
the link lights on the nic are on.  I know the lights on the switch are
on.

-----Original Message-----
From: EMAIL:PROTECTED
[mailto:EMAIL:PROTECTED] On Behalf Of Mark Rages
Sent: Thursday, February 17, 2005 9:42 PM
To: MLUG Members
Subject: Re: [MLUG] changing nics

On Thu, 17 Feb 2005 20:08:50 -0600, Nowlin, Dan <EMAIL:PROTECTED>
wrote:
> To start off I will let everyone know that I run Mandrake 10.1.
> OK. I had an intel e100 dual nic in my linux server.  I decided that I

> could use that card in another box to play with creating a router, so 
> I removed it from the server and installed a 3com card.  After the 
> reboot I ran harddrake and setup the nic.  When I restart networking 
> everything says it is OK.  I have the nic set with a static 1.200 IP, 
> the router I am using is 1.250, and another PC is at 1.1.  Here is the

> problem when I ping from the server I get the following:
> 
> ping 192.168.1.250
> >From 192.168.1.200 icmp_seq=1 Destination Host Unreachable
> 
> Anybody have any ideas what I did wrong?
> 

When I get that error, I usually have a cable unplugged.  If the cable
is between two nics, you need a crossover cable, right? are the link
LEDs lit?

Regards,
Mark
EMAIL:PROTECTED
--
"We act as though comfort and luxury were the chief requirements of
life, when all that we need to make us happy is something to be
enthusiastic about."

- Einstein
_______________________________________________
members mailing list
EMAIL:PROTECTED
http://mlug.missouri.edu/mailman/listinfo/members

_______________________________________________
members mailing list
EMAIL:PROTECTED
http://mlug.missouri.edu/mailman/listinfo/members